View level overview, Active charger settings, Remote stored profile – Computronic Controls Sentinel 300P User Manual
Page 10: Charger hardware, Charger dip switch settings, Global charger settings, Battery voltage graph, Charger current graph
SNTL300P-PCSUITE installation & operation
ci0042 p10/22 issue 5 2015-04-22
View Level Overview
If no password is entered when requested or environment level not changed then the Interface Suite works in view
mode only. From this setting the following two screens are available:
Charger settings screen
This provides information of the set conditions of
the SNTL300P.
Active Charger Settings
This provides information on what the SNTL300P
charger is currently configured to.
Remote Stored Profile
This provides information on what the SNTL300P
charger has stored when configured to Remote
Profile
Charger Hardware
The SNTL300P provides information on what
revision firmware it contains along with COMs board
firmware if attached.
Charger DIP switch settings
The current configuration of the DIP switches located
on the rear of the SNTL300P is shown.
Global Charger Settings
Battery Check Period and Charger Current Limit are
shown
Charger data screen
This provides a scrolling display of the chargers
output voltage and current.
Battery Voltage Graph
This displays a record of the chargers output voltage
(VDC)
Charger Current Graph
This displays a record of the chargers output current
(ADC)