Sntl300p configurable settings, Charger profiles, Preset charger profiles – Computronic Controls Sentinel 300P User Manual
Page 13
SNTL300P-PCSUITE installation & operation
ci0042 p13/22 issue 5 2015-04-22
SNTL300P Configurable Settings
Charger Profiles
Depending upon access password entered, the selection or creation of new charger profiles is available. The
configurable fields are as follows:
PROFILE NAME
Name of profile
FLOAT VOLTAGE
This should be according to manufacturer
recommendations for battery type, i.e. Wet Lead Acid =
2.25V/p/c = 12V Settings = 13.5Vdc
BOOST VOLTAGE
This should be according to manufacturer
recommendations for battery type, i.e. Wet Lead Acid =
2.23V/p/c = 12V Settings = 14.1dc
BOOST INITIATE VOLTAGE
The voltage at which the SNTL300P Initiates Boost
Function. This should be a voltage lower than Float
voltage, typically nominal (i.e. 12V or 24V)
BOOST PERIOD
Amount of Time for Charger to remain at Boost Voltage
before returning to Float
LOW ALARM VOLTAGE
Low Alarm Voltage Setting
HIGH ALARM VOLTAGE
High Alarm Voltage Setting
NUMBER OF CELLS
Used for correct calibration of Temperature
Compensation. If, such as in the case of Power Supply
modes, no temperature compensation is required enter
‘0’
Preset Charger Profiles
The SNTL300P contains an inbuilt list of the most common type of batteries used, these can be selected from the
drop down menu:
12V Wet Lead Acid
12V Wet Lead Acid for Fire Pump*
12V Calcium Calcium
12V Lead Acid Antinomy, Hybrid Sb-Ca (Antimony-Calcium)
12V VRLA
– AGM
12V VRLA
– Gel
10 Cell NiCd
12V Power Supply Mode
18 Cell NiCd
20 Cell NiCd
24V Wet Lead Acid
24V Wet Lead Acid for Fire Pump*
24V Calcium Calcium
24V Lead Acid Antinomy, Hybrid Sb-Ca (Antimony-Calcium)
24V VRLA
– AGM
24V VRLA
– Gel
24V Power Supply Mode
*Fire Pump Calibrations are only available on SNTL300P-FP Fire Pump Models