Dish Network EZ User Manual
Page 10
118866
9
7. Set the
switch on the back of the satellite
receiver to
CH4
. The TV will lose the picture from
the satellite receiver, but this is OK.
Note
: If your satellite receiver does not have a
switch, see your satellite receiver’s User’s Guide
for how to set
TV Set Out
on the satellite receiver to
channel 4.
8. Press and hold
until both
lights turn
on (it takes about five seconds).
9. Release
.
light will flash.
10.Enter
0
-
4
.
11.Press
MUTE
while watching
light.
12.
light will flash three times.
If the light does not flash at all, repeat this
procedure starting with step 8.
13.Press
while watching your TV. If your TV
tunes to Channel 4, go to step 14. If not, go to
step 7.
14.Press the
MENU
button. If you see the satellite
receiver
Menu
screen, check the box below and go
to step 28.
4
15. Answer the questions in Table 1. The information
you provide is what you will use to teach your
remote control to change the channel on your TV
correctly.
SAT
TV
SAT
SAT
SAT