Dish Network EZ - Manual (Page 6)

118866 5
R ECEIVER U PGRADE
Turn on your TV the way you normally would to watch
satellite TV programming. Using your DISH Network EZ
Remote Control, press
and then try using this remote
control to operate some basic satellite receiver features
like
MENU or GUIDE . If the remote control does not work,
your satellite receiver may need to get an upgrade from
the satellite. To receive this upgrade, turn off your
satellite receiver for 20 minutes. After completing the
upgrade, try using the remote control again to make sure it
works.
Note : Check the inside front cover of this guide to see if
the remote control is compatible with your satellite
receiver.
Note : If you are installing the satellite receiver for the first
time, you must use the remote control that came with your
receiver to guide the receiver through the installation
procedures, which includes getting the upgrade from the
satellite.
S ETTING U P TO S WITCH THE TV TO
W ATCH S ATELLITE P ROGRAMMING
The following instructions show you how to set up your
system and DISH Network EZ Remote Control so that
when you press
the TV gives you satellite
programming every time.
The first thing you will do is make the right connections
between the TV and satellite receiver. After that, you will
set up your remote control to work with your TV and then
set up
.