Dish Network EZ - Manual (Page 9)

8 118866
S ETTING U P ON Y OUR R EMOTE C ONTROL
• Press and to change channels on
your TV.
• Press to change the TV volume.
If these buttons work, go on to the next section to
set up
. If not, pick another code for your TV
brand from the TV Codes table and go back to
step 3.
1. Make sure your TV and satellite receiver are
connected and your remote control is set up to
control your TV using the instructions in the last
two sections.
2. Turn on your TV and tune to a channel other than 3
(for example, 4 or 5).
3. Press and your satellite receiver should turn on
and your TV should tune to Channel 3.
4. Press the MENU button. If you see the satellite
receiver Menu screen, go to step 5. If not, go to
step 15.
5. If you want to keep your satellite programming on
TV Channel 3, check the box below and go to step
28.
3
6. If you prefer to have your satellite programming on
TV Channel 4, go on to step 7.
VOL VOL