Dish Network EZ - Manual (Page 23)

22 118866
H OW TO S CAN FOR VCR C ODES
If the code for your VCR is not in the VCR Codes tables
starting on page 39, complete the following instructions to
scan for your VCR’s code.
1. Make sure your VCR is on.
2. Hold until lights turn on (it takes
about five seconds).
3. Release . light flashes.
4. Press the RECALL button. light stays on.
5. Press or until the VCR turns OFF. You
will have to do this repeatedly to scan through all
codes.
Note : If flashes eight times, you have tried
every code in the remote control.
6. Press the MUTE to finish programming the remote
control. The light will flash three times.
7. Press while looking at the channel number
display on your VCR. If the VCR is trying to
change channels to Channel 3 (or 4), you have
found the correct code for your VCR and you may
want to go back to page 17 to set up
. If the
VCR is not trying to change channels, go back to
step 2 to find another code.
Note : The way your VCR displays channel numbers
may differ from the description above. See the
User’s Guide that came with your VCR for more
information.
SAT TV
TV
TV
TV
TV