Dish Network EZ - Manual (Page 15)

14 118866
S
ETTING
U
P TO
P
ASS
S
ATELLITE
P ROGRAMMING T HROUGH Y OUR VCR TO
Y OUR TV
If you want to install a VCR between your satellite
receiver and your TV, follow these instructions to set up
your system and your remote control to switch your
system to watch satellite programming through your VCR
when you press
.
Note : The remote control setup for the VCR is only to
allow the to pass satellite programming through your
VCR. This remote control does not provide any buttons to
control standard VCR functions.
The first thing you will do is make the right connections
between your satellite receiver, VCR, and TV. After that,
you will set up your remote control. Before you can do
these instructions, you must first complete Setting Up
to Switch the TV to Watch Satellite Programming on
page 5.
10.Release . light flashes.
11.Press .
12.Press the MUTE button while watching the
light.
13.If the light flashes three times, go to step 14. If
does not flash at all, go back to step 9.
14.Press to make sure your TV tunes to the off-air
TV channel you wanted.
TV
TV
TV
TV