Dish Network EZ - Manual (Page 21)

20 118866
U SING W HEN A VCR IS I NSTALLED
If you installed a VCR using the instructions in Setting Up
to Pass Satellite Programming Through Your VCR to
Your TV on page 14, but you would like to use to
switch your TV to the preferred off-air channel, make sure
your VCR is turned off before pressing
.
16.If the information in step 2 on page 15 is a “3,”
write the numbers you circled in Table 2 into the
blank in step 21.
17.If the information in step 2 on page 15 is a “4,”
write the numbers you circled in Table 2 into the
blank in step 21, except replace the “3” with a “4.”
18.Press and hold until both lights turn
on (it takes about five seconds).
19.Release . light will flash.
20.Press the RECALL button.
21.Press .
22.Press the MUTE button while watching
light.
23.If the light flashes three times, go to step 24.
If light does not flash at all, go back to step 18.
24.Press . You should see both your TV and your
VCR change to the channel you wrote in step 21
above so that you can watch satellite programming.
25.Press the MENU button. If you see the satellite
receiver Menu screen, go to step 26. If not, go to
step 15 on page 18.
26.You are finished programming the remote control.
SAT TV
SAT
SAT
SAT
SAT