Dish Network EZ - Manual (Page 22)

118866 21
O THER R EMOTE C ONTROL I NSTRUCTIONS
H OW TO S CAN FOR TV C ODES
If the code for your TV is not in the TV Codes tables
starting on page 32, complete the following instructions to
scan for your TV’s code.
1. Make sure your TV is on.
2. Hold until lights turn on (it takes
about five seconds).
3. Release . light flashes.
4. Press . light stays on.
5. Press or until the TV turns OFF. You
will have to do this repeatedly to scan through all
codes.
Note : If flashes eight times, you have tried
every code in the remote control.
6. Press the MUTE to finish programming the remote
control. The light will flash three times.
7. Turn your TV back on by pressing again and
try the other buttons below to make sure they work.
• Press the 0 through 9 buttons to change channels
on your TV.
• Press and to change channels on
your TV.
• Press to change the TV volume.
If the buttons work, you have found the correct
code for your TV and you may want to go to page 8
to set up
. If the buttons do not work, go back to
step 2 to find another code.
SAT TV
TV
TV TV
TV
TV
TV
VOL VOL