Dish Network EZ - Manual (Page 25)

24 118866
H OW TO R EMOVE TV C ODES
If you decide to change the TV you are using with the
remote control, it is a good idea to remove the TV code
from the remote.
H OW TO R EMOVE VCR C ODES
If you decide to change the VCR you are using with the
remote control, it is a good idea to remove the VCR code
from the remote.
1. Press and hold until lights turn on (it
takes about five seconds).
2. Release . light flashes.
3. Press . stays on.
4. Enter 9-9-9-9 with the keypad.
5. Press the MUTE button.
6. The light will flash three times.
The TV code is now cleared from the remote
control’s memory. The TV channel also is reset
back to “
0 - 3 ” for the next time you set up a new TV
code in your remote control.
1. Press and hold until lights turn on (it
takes about five seconds).
2. Release . light flashes.
3. Press the RECALL button. stays on.
4. Enter 9-9-9-9 with the keypad.
5. Press the MUTE button.
6. The light will flash three times.
The VCR code is now cleared from the remote
control’s memory. The VCR channel also is reset
back to “
0 - 3 ” for the next time you set up a new
VCR code in your remote control.
SAT TV
TV
TV TV
TV
SAT TV
TV
TV
TV