Doremi CaptiView - Manual (Page 21)

D2K.DP.000469.DRM Page 21 of 27 Version 2.1
Doremi Labs
4.1 SMPTE 430-10 Protocol Set Up Via Ethernet Port

Remove either the AccessLink or CaptiLink from packing and begin to set up near a
power outlet and computer that has a free Ethernet port.

The default IP address of the SB430-10 is "192.168.9.10"

Set your computer's IP address in the range '192.168.9.xx', xx being in the range (2-254
except 10).

Connect the AccessLink or CaptiLink with an Ethernet cable to the newly configured port
and power on.

Download and install the program "PuTTY" (or any ssh client) on the computer you just
assigned the new IP address to.

Connect to the default IP 192.168.9.10 on port 22 using the ssh client.

When the unit is done booting up, login as root.
o Password for root is: "veeone"
o It is recommended to change the root password by typing the following command
and following the on-screen instructions: "passwd"
4.1.1 Configuring the IP Address for the AccessLink or CaptiLink

To configure the IP of the AccessLink or CaptiLink, type the following command:
o echo -n xxx.xxx.xxx.xxx > /doremi/etc/ip_addr (xxx.xxx.xxx.xxx = the desired
IP address) and then press the Enter key.

To configure the netmask, type the following command:
o echo -n xxx.xxx.xxx.xxx > /doremi/etc/netmask and then press the Enter key.

To configure the gateway, type the following command:
o echo -n xxx.xxx.xxx.xxx > /doremi/etc/gateway and then press the Enter key.
4.1.2 Adding the IP Address of a Digital Cinema Server to the AccessLink
or CaptiLink

To add the IP address, type the following command:
o echo -n xxx.xxx.xxx.xxx > /doremi/etc/s430-10/ip.conf and then press the
Enter key.

Reboot the SB430-10 for the changes to take effect.

Connect the CaptiView Transmitter to the USB port on the AccessLink or CaptiLink and
then go back to Section 2 of this manual to finish the setup.