Doremi CaptiView - Manual (Page 22)

D2K.DP.000469.DRM Page 22 of 27 Version 2.1
Doremi Labs
4.2 SMPTE 430-10 Protocol Set Up Via Serial Port

Remove the AccessLink or CaptiLink from packing and begin to set up near a power
outlet and computer that has a serial port.

The serial cable required for a proper connection is a female to female pin to pin cable,
which should be provided in the package.
o Serial connection settings are: Speed 115200, Data bits: 8, Stop bits: 1, Parity:
None, Flow control: None
o Connect and switch the device on and wait for it to boot.

When the unit is done booting up, login as root.
o Password for root is: "veeone"
o It is recommended to change the root password by typing the following command
and following the on-screen instructions: "passwd"
4.2.1 Configuring the IP Address for AccessLink or CaptiLink

To configure the IP of the AccessLink or CaptiLink, type the following command:
o echo -n xxx.xxx.xxx.xxx > /doremi/etc/ip_addr (xxx.xxx.xxx.xxx = the desired
IP address) and then press the Enter key.

To configure the netmask, type the following command:
o echo -n xxx.xxx.xxx.xxx > /doremi/etc/netmask and then press the Enter key.

To configure the gateway, type the following command:
o echo -n xxx.xxx.xxx.xxx > /doremi/etc/gateway and then press the Enter key.
4.2.2 Adding the IP Address of a Digital Cinema Server to the AccessLink
or CaptiLink

To add the IP address, type the following command:
o echo -n xxx.xxx.xxx.xxx > /doremi/etc/s430-10/ip.conf

Power cycle the AccessLink or CaptiLink for the changes to take effect.

Connect the CaptiView Transmitter to the USB port on the AccessLink or CaptiLink and
go back to Section 2 of this manual to finish the setup.