Junger Audio d06 - Digital Audio Leveler - Manual (Page 18)

3. INSTALLATION
operation manual d06, chapter 3 - Installation - page 4 of 10
The digital audio level processor d06 can be remote-controlled by means of
parallel GPI inputs.
Use to :
* recall of PRESETs 1-4
* switch between STEREO / 2CH link mode
* selection of INPUT 2 / 1
* switching the device to BYPASS
Connector :
D-SUB 15pin, female
Pin assignment of the connector :
Pin Signal name Functions
1 GPI1 in Defined by d06 config
2 GPI2 in Defined by d06 config
3 GPI3 in Defined by d06 config
4 GPI4 in Defined by d06 config
5 GPI5 in Defined by d06 config
6 GPI6 in Defined by d06 config
7 GPI7 in Defined by d06 config
8 GPI8 in Defined by d06 config
9 + 5V 110 Ω
10 GPI1/GPI2 common
11 GPI3 common
12 GPI4 common
13 GPI5 common
14 GPI6 common
15 GPI7/GPI8 common
Shield -5V GND of d06 Chassis
Electrical specification :
GPI input
potential free by opto-coupler in line with
a current source
ON:
+3.5…+30V between GPIx input
and GPx common
OFF: less then 1.5V between GPIx input
and GPIx common
For serial numbers S/N 59 and higher (HW Revision 2a and higher) the
polarity of the GPI inputs has been changed. to make use of the internal
ground based auxiliary 5 V for "low active" switching.
ON:
-3.5…-30V between GPIx input
and GPx common
OFF : less then 1.5V betwee GPIx input
and GPIx common
Signal duration must be at least 50msec.
Note :
An internal auxiliary voltage feed of +5V is available on pin 9
via a 110 Ω resistor. Ground is available from the shield of the connector
only! When using the auxiliary voltage feed, there is no electrical isolation
given anymore and the risk to inject unwanted noise is high!
Important Note : You must take care about the polarity of the external voltage
applied to the GPIs. Wrong polarity may destroy electronic components
and may cause fire inside the d06!
3.7.2
GPI