Junger Audio d06 - Digital Audio Leveler - Manual (Page 25)

4. NETWORK INTERGRATION
operation manual d06, chapter 4 - Network Integration - page 1 of 6
NETWORK INTEGRATION
To control the Junger audio devices via web browser you must set up an
TCP/IP over Ethernet connection. If you are not familiar with the network
setup, please consult a network administrator for assistance and read ALL
the manual carefully!
There are two ways to communicate with the device via Ethernet:
1. You can connect the device to the LAN your PC is integrated
(if there is one existing already)
2. You can connect the device directly to your PC using an
Ethernet crossover cable.
In both cases network settings of the device or your PC or even both have to be
changed and matched.
The default network configuration of the Jünger devices is:
IP Address : on a label at the LAN connector socket at the rear of the device
Netmask :
255.255.0.0.
Gateway : 10.110.0.1.
1. Integration into an existing LAN
When you want to integrate the device into an existing LAN you have to
change its IP-address, the (sub) network mask and the gateway. You will get
valid settings from your network administrator.
You can do that two ways :
A
Connecting the device over a serial cable to your PC and change the
network configuration with a terminal program (e.g. HyperTerminal
included in Windows installation)
B
Disconnect your PC from your LAN (physically), match your PC’s
IP setup to the setup of the device for getting access to the device via
Ethernet crossover cable, change the device’s network configuration via
Ethernet crossover cable. Then change again your PC’s configuration
and connect both your PC and the device to the LAN.
4