Junger Audio d06 - Digital Audio Leveler - Manual (Page 27)

4. NETWORK INTERGRATION
operation manual d06, chapter 4 - Network Integration - page 3 of 6
You will get to the Hyper terminal window:
Press ENTER and you will get a similar window :
Now you can change the network configuration so that it fits into your LAN.
You might have changed the IP-address of the device, so please renew the
label at the rear of the device, otherwise it will cause confusion.
When you ever “Restore factory defaults” (i.e. initializing the device) the
default IP-address and network configuration will be active again. In case of
need you can read the default IP-address always on the controller in the
device!
B)
You can also change the IP address of the device over Ethernet connection.
Disconnect your PC from the LAN, connect it to the device directly via
Ethernet crossover cable (not connected 1 to 1, but 1 to 8 etc…).
Change the network configuration of your PC
(write down the current settings,
you need them later to reconnect to your LAN!) via the
“Local Area Connection Properties” menu (Windows: Start -> Control Panel ->
Network connections -> Local Area Connection -> Local Area Connection
Status -> Properties -> Internet Protocol (TCP/IP).