KBC Networks MPEG4 Encoder - Manual (Page 17)

Encoder User Manual
Manual-MPEG4_ENCA-Rev1206
Copyright © KBC Networks 2011
Page 17 of 33 www.kbcnetworks.com
3.3.2.2 Language
See section 3.1.2.1 for language options. It is in this section where the selected
language will remain even after logging out.
Note: If the parameters of sections 3.3.2.1 and 3.3.2.2 have been changed from
default, you must click “Apply” to save those changes. The encoder must also
go through a reboot process by clicking on “>>Save Reboot” from the menu on
the left of the web browser.
3.3.2.3 Network Link Speed & Duplex
If a certain speed and duplex setting is required other than auto-detect, it can be
selected in this section. Other options include:
 100 Mbps / Full Duplex
 100 Mbps / Half Duplex
 10 Mbps / Full Duplex
 10 Mbps / Half Duplex
Note: If the Network Link Speed & Duplex parameters have been changed from
default configuration, you must click “Apply” to save those changes. The
encoder must also go through a reboot process by clicking on “>>Save Reboot”
from the menu on the left of the web browser.
3.3.2.4 Type of Service
The TOS tag priority can be added to the streaming. The options are:
 Normal-Service (default configuration)
 Minimize-Cost
 Maximize-Reliability
 Maximize-Throughput
 Minimize-Delay
Note: Click on “Apply” in this section of the web browser GUI to apply changes to the
type of service.
3.3.2.5 Port Mapping
 Select the port for this encoder to use HTTP protocol.
 Select the first port on which software applications, such as the IP Utility, can
locate this encoder.
 Select the second port on which software application, such as the IP Utility, can
locate this encoder.
Note: Click on “Apply” in this section of the web browser GUI to apply changes to the
port mapping.
3.3.3 WAN Setting
The WAN Setting is where the network properties of the encoder are configured.
Keep a record of changes or use the IP Utility to find the IP addresses if changed
from default configurations.
3.3.3.1 Dynamic IP Address
When selected the IP address of the encoder will be set automatically provided that
the encoder is connected to a DHCP router.
3.3.3.2 Static IP Address
KBC recommends selecting a static IP on the network. Advise the network
administrator for available static IP addresses prior to configuring the encoder on the
local network.