Signamax Model -065-7700 - Manual (Page 118)

Hardened Managed PoE Ethernet Switch
User’s Manual 117
4. Example:
The following example shows the ARP Table of switch:
switch_a#show arp-table
Route Table
1.
Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2.
Usage:
Use show route-table command to view Route Table.
3.
Command Syntax:
show route-table
4.
Example:
The following example shows the Route Table of switch:
switch_a#show route-table
Save Configuration
Load config from TFTP server:
1.
Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2.
Usage:
Use install image command to load configuration file from tftp server to
switch.
3.
Command Syntax:
install image IP-ADDRESS WORD
IP-ADDRESS specifies the IP address of tftp server.
WORD specifies the file name to be loaded to switch.
4.
Example:
The following example specifies upgrading firmware (file name: flash.tgz)
from tftp server (IP address: 192.168.1.100) to switch:
switch_a#install image 192.168.1.100 flash.tgz
switch_a#