Signamax Model -065-7700 - Manual (Page 132)

Hardened Managed PoE Ethernet Switch
User’s Manual 131
Use storm-control multicast enable command to enable multicast traffic.
Use no storm-control multicast command to disable multicast traffic.
3.
Command Syntax:
storm-control multicast enable
no storm-control multicast
4.
Example:
The following example shows setting storm-control multicast enable to the
interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control multicast enable
switch_a(config-if)#
DLF:
1.
Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface fe1
switch_a(config-if)#
2.
Usage:
Use storm-control dlf enable command to enable destination lookup failure
traffic.
Use no storm-control dlf command to disable destination lookup failure
traffic.
3.
Command Syntax:
storm-control dlf enable
no storm-control dlf
dlf destination lookup failure
4.
Example:
The following example shows setting storm-control dlf enable to the
interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#storm-control dlf enable
switch_a(config-if)#
Static MAC Entry
Static-MAC-Entry Forward:
1.
Command Mode: Configure mode