Signamax Model -065-7700 - Manual (Page 123)

Hardened Managed PoE Ethernet Switch
User’s Manual 122
Alarm Setting
Alarm-trigger if:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to enable or disable alarm trigger on interface.
3.
Command Syntax:
(no) alarm-trigger if INTERFACE
INTERFACE specifies the interface.
4.
Example:
The following example enables alarm trigger on interface “fe1” to switch:
switch_a(config)#alarm-trigger if fe1
switch_a(config)#
Alarm-trigger power:
1.
Command Mode: Configure mode
Logon to Configure Mode (Configure Terminal Mode).
The switch_a(config)# prompt will show on the screen.
switch_a(config)#
2.
Usage:
Use this command to enable or disable alarm trigger of power source.
3.
Command Syntax:
(no) alarm-trigger power POWER
POWER specifies the power source.
4.
Example:
The following example enables alarm trigger of power “1” to switch:
switch_a(config)#alarm-trigger power 1
switch_a(config)#
Reboot
1.
Command Mode: Privileged Exec mode
Logon to Privileged Exec Mode (Enable Mode).
The switch_a# prompt will show on the screen.
switch_a#
2.
Usage: