Digi Counting Version 4.0 DC-190 - Manual (Page 15)

20 DC-190 Ultra Count Installation Manual
15 0011 RS-232C Stop Bits
(Barcode pen)
0: 1 Bit
1: 2 Bits
RS-232C with Header
(Barcode pen)
0: Yes (first character
recognized as
header)
1: No (every bar code
treated as ID code)
RS-232C Parity Bit (Barcode pen)
00: No 01: Odd
10: Not used 11: Even
NOTE: All scale channels must be assigned in SPECs 16 and 17, regardless of the actual number of scales attached. See
Section 3.1.1 on page 12 for detailed information about configuring these SPECs.
16 0001 Scale 1
00: Internal Scale 1
01: Internal Scale 2
10: External Scale
11: Force Balance
Scale 2
00: Internal Scale 1
01: Internal Scale 2
10: External Scale
11: Force Balance
17 1011 Scale 3
00: Internal Scale 1
01: Internal Scale 2
10: External Scale
11: Force Balance
Scale 4
00: Internal Scale 1
01: Internal Scale 2
10: External Scale
11: Force Balance
18 0000 Setpoint TTL Output
0: Active low (0V)
1: Active high (+5V)
Number of Setpoints. Values for 3–6 setpoints are valid only if SPEC 7, bits 0
and 1, are set to 10 or 11 (Quantity or Weight).
000: 2 setpoints
001: 3 setpoints
010: 4 setpoints
011: 5 setpoints
100: 6 setpoints
19 1000 Display “not F”
Message for Items not
Stored in Memory
0: Yes
1: No
Link to IMS (US version)
0: No
1: Yes
Type of Force Balance
(Japan version only)
0: SHG-300
1: HR-60
Print when Pressing + or
– Key in Add Mode
0: Yes
1: No (print only with
* )
SPEC Default Bit 3 Bit 2 Bit 1 Bit 0
Table 4-1. DC-190 141 Settings (Continued)