Digi Counting Version 4.0 DC-190 - Manual (Page 29)

52 DC-190 Ultra Count Installation Manual
10.3 Connector Pinouts
The DC-190 provides CTS/RTS hardware handshaking lines on both the 8-pin DIN and 9-pin D-Sub connectors.
For devices that do not require hardware handshaking, short the CTS/RTS lines on the scale side of the cable.
8-Pin DIN Female
Figure 10-1. 8-Pin DIN Female
14-Pin Amphenol
Figure 10-2. 14-Pin Amphenol Female
9-Pin D-Sub Female
Figure 10-3. 9-Pin D-Sub Female
Setpoint Mini DIN
Figure 10-4. Setpoint Mini DIN Female
Pin
Number
Scanner DIN
Connector
Force Balance DIN
Connector
1 DTR DTR
2 SIGNAL GND SIGNAL GND
3 DSR DSR
4 RXD RXD
5 TXD TXD
6 CTS CTS
7 RTS RTS
8 Vcc (5 V) N/C
Table 10-6. Eight-Pin DIN Connector Pin Assignments
Pin Number
Remote Platform Connector
Description
1 Not used
2
3 +EXCITATION
4 –EXCITATION
5 SHIELD*
6 +SIGNAL
7 –SIGNAL
8 GROUND*
9 through 14 Not used
* When using the Y cable, use pin 5 instead of pin 8 as
ground.
Table 10-7. Remote Platform Pin Assignments
Pin Number Description
1 DCD
2 RXD
3 TXD
4 DTR
5 SIGNAL GND
6 DSR
7 RTS
8 CTS
9 RI
Table 10-8. 9-Pin D-Sub Connector Pin Assignments
Pin Number Setpoint Configuration
1 SP-1
2 SP-2
3 SP-3
4 SP-4
5 SP-5
6 SP-6
7 +5V
8 GND
Table 10-9. Setpoint Configuration Pin Assignments