Adtec digital mediaHUB-HD 422 (version 1.01.10_M_2) Manual - Manual (Page 78)

eth0 DHCP
check box, allows unit to extract it's own IP address if switched
on, from a DHCP server selected = 1
not selected = 0 *.SYSD
DHC eth0
eth0 Ethernet
Address
IP address of the unit's Control-Ethernet port 10/100mbps
text field; valid IP address in
form
xxx.xxx.xxx.xxx
*.SYSD IPA
0
eth0 Subnet
Mask
Subnet mask address of the unit's Control-Ethernet port
text field; valid IP address in
form
xxx.xxx.xxx.xxx
*.SYSD IPM
0
eth1 DHCP
check box, allows unit to extract it's own IP address if switched
on, from a DHCP server selected = 1
not selected = 0 *.SYSD
DHC eth1
eth1GigE
Address
IP address of the unit's GigE port
text field; valid IP address in
form
xxx.xxx.xxx.xxx
*.SYSD IPA
1
eth1 Subnet
Mask
Subnet mask address of the unit's Control-Ethernet port
text field; valid IP address in
form
xxx.xxx.xxx.xxx
*.SYSD IPM
eht1
NTP Address IP Address of a Network Time Protocol server
On = 1
Off = 0
used in conjunction with the
server's IP address
*.SYSD NIP
[state][IPA]
Time Zone
designate operating time zone of unit for timekeeping and
internal scheduling
Will auto-populate if unit is connected to an NTP Server. text field- will auto-populate
from NTP server if NTP
enabled
*.SYSD TIZ
Date
set the date for the unit for timekeeping and internal
scheduling
Will auto-populate if unit is connected to an NTP Server. text field- will auto-populate
from NTP server if NTP
enabled
*.SYSD
TIM
Time
set system time for unit for timekeeping and internal
scheduling
Will auto-populate if unit is connected to an NTP Server. text field- will auto-populate
from NTP server if NTP
enabled
*.SYSD TIM
www.adtecdigital.com