Artesyn MVME8100/MVME8110 Installation and Use (September 2014) - Manual (Page 45)

Hardware Preparation and Installation
MVME8100 / MVME8110 Installation and Use (6806800P25G) 45
8. Replace the chassis or system cover.
9. Reconnect the system to the power source and then turn on the system.
2.5.3 SATA Installation
A 2.5" SATA drive can be installed in PMC/XMC site 2. The MVME8100-HDMTKIT4 SATA
mounting kit (6706881A01x) provides the mounting hardware. A SATA drive which meets the
intended board operating environment for temperature and vibration must be used.
Figure 2-3 Typical Placement of a PMC/XMC Module on a VME Module