ATEIS DIVA8G2 - Manual (Page 11)

Safety Declartion 11
© 2012 ATEÏS
To prevent the unit from falling down and causing personal injury and/or property damage, avoid
installing or mounting the unit in unstable locations.
Leave enough space above and below the unit to provide good ventilation of the device. If the airflow is
not adequate, the device will heat up inside and may cause a fire.
Operate the device in an environment with a free-air temperature of between 0 °C and 40 °C (32 °F and
104 °F).
Turn off all audio equipment when making any connections to the device, and make sure to use
adequate cables.
Do not use benzene, thinner, or chemicals to clean the device. Use only a soft, dry cloth.
If the device is moved from a cold place (e.g., overnight in a car) to a warmer environment,
condensation may form inside the unit, which may affect performance. Allow the device to acclimatize
for about one hour before use.
3 Quick Start
This topic is designed for "Quick Stat" and is only intent to give a rapid overview of how to start with
DIVA. To obtain more precise details on "how to" and for further information about more complex
configuration possibilities, please read all topics in this manual.
Basic Setup
Connections and Power Up
Fireman Microphone
o Connect the fireman microphone to the connector on the DIVA's front panel.
Music Sources:
o Connect a tuner on the Cinch connector labeled 1 under "Music Input" on the rear of
DIVA.
o Connect a CD player on the Cinch connector labeled 2 "Music Input"
Speaker Lines
o Connect one speaker line to the "Zone 1" connector. The speaker positive cable should
be connected to "LINEA+" and the negative cable to "LINEA-"
o Connect a second speaker line to the "Zone 1" connector. The speaker positive cable
should be connected to "LINEB+ and the negative cable to "LINEB-"
o If more zones have to be used, please redo the same connection for ZONE2, ZONE3,
etc...