ATEIS DIVA8G2 - Manual (Page 175)

System Functionality 175
© 2012 ATEÏS
in two different manner. Static will close it until the event stop and Pulse will generate a closing
pulse whose length can be defined from 50 to 60000 ms.
Stop Impulse: This option is used to create a closing contact pulse when the event is finished.
The length of the pulse can be defined from 50 to 60000 ms.
ACK Relay: You can specify here an logic output channel that will be closed when the event is
active.
Busy Relay: Here you can specify an Logic Output Channel relay that will be closed as soon as
a higher priority event is active in one of the pre-define zones.
Set the play message event option to suit your needs.
The bottom part of the Evac Configuration form is dedicated to create the phase evacuation. After having
enabled an evacuation input, you have to define in which zones the messages will be played.
For each evacuation input (CH1 to CH8), select the routing of Evac event and Alert event by
clicking into the boxes, see next picture
Define the corresponding Evacuation Input activation mode, see chapter "How to Evacuation