Avalon Firestyles 796-1990 to 1993 - Manual (Page 10)

Page 10
FREESTANDING OPTIONAL EQUIPMENT (Continued)
5. Avalon Blower, Rear (Continued)
4. The blower has a control box which needs to be attached to the pedestal body. With the stove
attached to the pedestal, locate the hole on the right side of the pedestal. Remove the knob on the
control box and the nut that is on the threaded shaft located directly behind where the knob was.
Feed the control box and wiring into the pedestal until the threaded shaft is directly behind the hole in
the pedestal. Insert the threaded shaft through the hole from the back and re-attach the nut until the
control box is secure against the pedestal. Re-attach the knob.
To Power Supply
Stove
Pedestal (Shown Transparent)
Hole in pedestal
Control Box
Blower Housing
5. Plug in the blower and test its operation. It should blow air out of the vent on top of the stove. The
blower is turned off by turning it all the way counter-clockwise. Turning the knob clockwise will
decrease the speed of the blower.
6. Universal Blower, Rear (For 996 Flush Top Flue Only)
The universal rear blower is designed to improve the natural convection of the stove by pushing air
through the convection chamber of the stove and causing the heated air to exit through the vents along
the top of the stove. The blower mounts to the back of the stove centered on the lower edge with three
screws. It also has a thermodisk assembly which turns the blower on and off automatically. Follow the
directions below to attach the blower.
1. Before installing the blower, first remove the two knock-outs on the bottom rear edge of the stove by
prying them out with a screwdriver. They are approximately 1" by 6" and are located near the rear
edge of the stove.
Do not remove. This knock-out is on
some models for the Avalon rear blower.
Remove these knock-outs for the
universal rear blower.
Do not remove. The front knock-out
is for the outside air connection.