Avalon Firestyles 796-1990 to 1993 - Manual (Page 26)

Page 26
FREESTANDING INSTALLATION (Cont.)
Mobile Home Installation
When installing a wood burning stove in your mobile home you must follow the same procedures and
regulations outlined in the sections "PREPARATION FOR INSTALLATION - FREESTANDING " and
"FREESTANDING INSTALLATION - SPECIFICATIONS".
NOTE: You may not install a wood burning stove in the bedroom of a mobile home.
Follow the directions for installation according to the type of chimney installed (factory-built chimney with
either a standard ceiling, cathedral ceiling, or horizontal outside chimney). In addition to the normal
residential requirements, the following requirements are mandatory for installation into a mobile home:
1. The stove must be permanently bolted to
the floor of the mobile home. (Some
states do not require this; check with
your local building department.)
2. The stove must have a permanent
outside air (combustion air) intake. The
Pedestal Option is equipped with
provisions for outside air. Please see
the instructions for the Outside Air Kit
and Outside Air Boot in the section
"FREESTANDING OPTIONAL
EQUIPMENT".
3. The stove must be grounded to the steel
chassis of the mobile home (Some
states do not require this; check with
your local building department).
CAUTION: The structural integrity of the
mobile home floor, wall, ceiling and roof
must be maintained.
Pedestal
Bolted to
Floor
Unit
Grounded
to
Chassis
Permanent Outside
Air Inlet (Direction is
Optional)