Belshaw Adamatic INSIDER Ventless Donut System - Manual (Page 27)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Insider TS MN-1853EN 1
1 Installation
Unpacking the Insider
Use a forklift to transport the shipping crate to
the workstation.
• Break down the shipping crate.
• Remove the packing materials from the
Insider, including foam, tape, brown paper,
plastic, and white protective coating. Do not
remove the plastic from the Plexiglas doors at
this time.
• Inspect the machine to see that no parts are
bent, scratched, or otherwise damaged. If any
damage has occurred in shipping, file a
freight claim with the shipping company
immediately.
• Mail the attached warranty registration form
within ten days of installation.
• Keep this manual for future reference. Put it
where you know you can find it.
Initial Cleaning
Remove all the packing materials. Wipe the
Insider with a soft, damp cloth. Dry these areas
completely.
WARNING
To avoid electrocution or other injury,
turn off the machine’s main power before
attempting any cleaning, disassembly,
adjustment, or repair.
NOTICE
”IN CASE OF FIRE”
Instructions for manually operating the
fire suppression system are posted
conspicuously on the insider hood and
should be reviewed periodically with
employees by the management. Only
persons properly trained and qualified to
install the specific system being provided
must make installation and charging of
systems. The installer must certify to the
authority having jurisdiction that the
installation is in complete agreement with
the terms of the listing and the
manufacture instructions and/or
approved design.
WARNING
Always dry floor after washing equipment
Replacement Air
Replacement air quantity must be adequate to
prevent negative pressures in the commercial
cooking area(s) from exceeding 0.02-inch water
column (4.98 Pa).
Required Placement
When the Mark II, V, or IX Fryer is installed in
the insider cabinet. It must be located on the
lineup pins to provide the proper placement.