Belshaw Adamatic INSIDER Ventless Donut System - Manual (Page 37)

Belshaw Bros., Inc. • www.belshaw.com • Phone 206-322-5474 • Fax 206-322-5425
Insider TS MN-1853EN 11
Illustration H
Fusible Link Connection
Hook the bottom of the link onto the bottom leg
of the hanger. See Illustration I
Illustration I
Fusible Link/Hanger Connection
Center the hanger/link in the fusible link bracket
by sliding it along the link line. This is easily
accomplished before any tension is applied to the
link line. Repeat this procedure for all fusible
links.
After the last hanger/link in the series is
connected, the cable should be fed through the
hole in the fusible link ratchet wheel. The line
must then be crimped, and the crimp positioned
inside the center of the ratchet wheel.
NOTE
Crimps must always be used in
conjunction with two (2) cable lengths.
Loops are the accepted method of
connecting the cable to mechanical
components. The crimp must never be
used on a single cable.
The fusible link line can now be put into a set
position by applying tension to the fusible link
line. This is accomplished by using a ¾” socket
on the fusible link line ratchet wheel. The
ratchet wheel will be ratcheted in a clockwise
direction until the spring plate makes contact
with the top of the control head box. The fusible
link line is now in a set position. See Illustration
F. Check to ensure that the fusible link hanger(s)
remain centered in the bracket after the fusible
link line is set. See Illustration J.
Illustration J
Fusible Link/Hanger In Set Position
e) Setting the Control Head
Model NMCH Mechanical Control Head
Once the fusible link line is set, the control head
can be placed in the set position. To set the
control head, the slide plate is moved from right
to left, ensuring the bolt extending from the cam
arm is in the slot provided in the slide plate.
Continue moving the slide plate to the left until
the latching arm is in the locked position. Insert
the pull pin into the hole in the slide plate above
the latching arm. This will lock the control head