Datalogic Scanning FALCON 4400 SERIES - Manual (Page 68)

Accessories
A-8 Falcon ® 4400 Series with Windows Mobile ®
Installing the Handle or Handstrap
The Falcon 4420 comes from the factory with the handle installed. The Falcon
4410 comes with a handstrap. These can be exchanged with a change-out kit.
The handle is removable and can be replaced with a handstrap. When you
replace the handle with the handstrap, you lose the ability to press the trigger
on the handle and must use the
<Scan> key on the Falcon keypad instead.
To remove the handle and replace it with the handstrap refer to the following
sections. Reverse the same directions to replace the handstrap with the handle.
Installing the Handstrap on the Falcon 4420
Install a handstrap on the Falcon 4420 by completing the following steps:
1. Remove the handle as shown in Figure A-11 by removing the screws
located just above the battery cover’s latch dials.
2. Insert the top tab of the handstrap cover into the slot at the top of the
handle recess. (refer to Figure A-10 )
The <Scan> key is not available on models with the 48-key keypad.