Datalogic Scanning FALCON 4400 SERIES - Manual (Page 98)

Programming Parameters
E-2 Falcon ® 4400 Series with Windows Mobile ®
• Scanner Type shows, with a checkmark, which modules support the
specified parameter.
Programming Codes Without Parameters
The following table describes the functions of special bar codes that take no
parameters:
Table E-1. Programming Codes Without Parameters
Code
Parameter
I.D. # Function
Defaults
Minimum
FF39
Turns every On/Off parameter off and sets all minimum and
Maximum Label Lengths to the lowest values.
Defaults
Maximum
FF3A
Turns every On/Off parameter on and sets all minimum and
Maximum Label Lengths to the highest values. This default set
is normally used only for troubleshooting. It gives the best
chance of reading an unknown bar code symbology and also
identifies the symbology of each bar code scanned.
Defaults
Factory
FF3B
This is the default parameter settings that was installed at the
factory. This default set will work for most applications.
Defaults
Registry
FF3C
This restores all parameter settings to the values that exist in
the registry. This is useful for restoring parameters to a known
working set of values which have been saved using code
parameter
FF3F .
Exit and
Restore
FF3D
Stops a label programming sequence and restores all parame-
ter settings to the values that exist in the registry.
Exit and
Save
FF3E
Stops a label programming sequence. The last valid parameter
settings are left intact.
Exit and
Commit
FF3F
Stops a label programming sequence and writes all parameter
settings into the registry. This can be used to save a custom-
ized set of parameter settings for restoring later via parameter
FF3C
.