Datalogic Scanning FALCON 4400 SERIES - Manual (Page 69)

Installing the Handle or Handstrap
Product Reference Guide A-9
Figure A-10. Removing/Replacing a Handstrap
3. Replace the screws located just above the battery cover’s latch dials.
4. Connect the handstrap hook onto one of the strap studs at the base of
the Falcon.
5. The process is complete upon successful test of the scanning function.
Installing a Handle on the Falcon 4410
Install the handle on the Falcon 4410 by completing the following steps:
1. Remove the handstrap as shown in Figure A-10 by removing the
screws located just above the battery cover’s latch dials.
Cover
Plate
Retaining
Pin
Retaining Pin
is threaded
through loop
in strap and
seated in sockets
Handstrap
Handstrap
PDT
Cover
Plate