Datalogic Scanning FALCON 4400 SERIES - Manual (Page 71)

Tethered Stylus
Product Reference Guide A-11
Tethered Stylus
An optional Tethered Stylus is available
for use on any of the Falcon 4400
series models. The Tether attaches the
stylus to the Falcon unit, preventing
the stylus from accidentally being lost
or misplaced.
Installing a Tethered Stylus
If your Falcon did not come with a Tethered Stylus, it can be easily installed.
Install a Tethered Stylus on the Falcon 44xx as follows:
1. Turn the Falcon face-down. Ensure that power is OFF.
2. Using a Phillips screwdriver, remove the 6 mm screw at the bottom of
the Stylus holder.
3. Use the longer 16 mm screw included with the Tethered Stylus kit to
attach the Tethered Stylus to the Falcon.
4. Slide the other end of the Tether through the Stylus.
This completes installation of the Tethered Stylus.
Tether
CAUTION
Do not use the 16mm long screw that came with the Tethered Stylus without the
Tether. Damage to internal components could occur if the screw is used without
the Tether, since the screw is longer than the standard 6 mm screw used without
the Tether.