Datalogic Scanning FALCON 4400 SERIES - Manual (Page 72)

Accessories
A-12 Falcon ® 4400 Series with Windows Mobile ®
Figure A-12. Installing/Removing a Tethered Stylus
Removing a Tethered Stylus
If you want to remove the Tether from your Falcon 44xx, complete the follow-
ing steps:
1. Turn the Falcon face down. Ensure that power is OFF.
2. Using a Phillips screwdriver, remove the 16 mm screw at the bottom
of the Stylus holder that attaches the Tether to the PDT.
3. Use the shorter 6 mm screw included with your Falcon to reattach the
Stylus Holder to the Falcon.
Removal of the Tethered Stylus is complete.
Tether
Screw
CAUTION
Do not use the 16 mm long screw that came with the Tethered Stylus without the
Tether. Damage to internal components could occur if the screw is used without
the Tether, since the screw is longer than the standard 6 mm screw used without
the Tether.