Beurer BM 49 - Manual (Page 50)

50
7. Saving, displaying and deleting measurements
Whilst the message is being displayed, the volume can be adjusted with the function buttons .
Voice output when voice function
is active
User memor
y
The results of every successful measurement are stored together
with the date and time. If there are more than 60 measurements, the
oldest measurements are lost.
• Switch on the device with the Start/stop button.
The device is ready for use.
You may start measuring.
• Select the desired user memory ( or ) by pressing the function
buttons .
User memory 1
User memory 2
Aver
age values
• Press the Memory button . The average value of all saved meas-
ured values in this user memory is displayed first .
• If you press the Memory button again, the average value of the
morning measurements for the last 7 days will be displayed (morn-
ing: 5 a.m. – 9 a.m., display ).
• If you press the Memory button again, the average value of the
evening measurements for the last 7 days will be displayed (even-
ing: 6 p.m. – 8 p.m., display ).
Average count:
Systole ... mmHg
Diastole ... mmHg
Heart rate ... beats per minute
According to the WHO guide-
lines your blood pressure is ...
Individual measur
ed values
• If you continue to press the Memory button , the most recent
individual measured values are displayed in turn with the date and
time.
Memory space ...
Systole ... mmHg
Diastole ... mmHg
Heart rate ... beats per minute
According to the WHO guide-
lines your blood pressure is ...
Delet
e measur
ed values
• The measured values in the corresponding user memory can be
deleted by switching on the device, selecting the desired user
memory and pressing the function buttons and simultaneously
for 5 seconds .
All the counts in the memory
have been erased.
• The device will go directly into standby mode (clock mode).
8. Error message/trouble shooting
In the event of errors, the error message _ appears on the display.
Error messages can occur when
1. it was not possible to record the pulse ( ),
2. you move or speak during the measurement ( ),
3. the cuff is fastened too tightly or loosely ( ),
4. errors occur during the measurement ( ),
5. the pump pressure is higher than 300 mmHg ( ),
6. the batteries are almost empty ( ).