Beurer GL 40 (mg/dL) - Manual (Page 23)

Beurer GL40 mg/dL 23
Note
• If you have already saved measured values and you reset the date, the average values are calculated
as from the new period.
• “---” indicates that the measured value memory is empty. Press the ON/OFF button to switch off the
unit.
6.1 Displaying individual values
The individual values of the last 480 measurements are displayed. The most recent value is displayed
first, and the oldest value is displayed last. The measuring device also displays the date and time
of the measurement.
1
The measuring device must be switched off. Press the or rocker button [5].
2 The start display appears briefly.
"MEM" and the number of stored blood glucose tests are displayed briefly (Fig. 1).
Then the stored value is displayed with the measuring unit, date, time and "MEM" (Fig. 2).
Image 1 Image 2
3
Every time you press the rocker button [5] again, the memory position number appears
followed by the previous measured value. You can display a maximum of 480 previous
measured values.
4 You can cancel the process at any time. To do so, press the ON/OFF button or wait until
the unit switches off automatically after 1 minute.
6.2 Displaying average blood glucose values
You can display the average blood glucose value from the last 7, 14, 30 and 90 days.
1 The measuring device must be switched off. Press the rocker button [5].
The start display appears briefly.
Press the rocker button [5] again.
The blood glucose level unit, "7 days" and the average value are displayed.
2
Press [5] repeatedly to display the average value for 14, 30 and 90 days.