Beurer GL 40 (mg/dL) - Manual (Page 24)

24 Beurer GL40 mg/dL
3 You can cancel the process at any time. To do so, press the ON/OFF button or wait until the
unit switches off automatically after 1 minute.
Pos. Explanation
1
2
1 Average value
2 Number of days, e.g. 7
6.3 Deleting the measured value memory
1 The measuring device must be switched off.
2 Remove the batteries from the battery compartment.
3 Simultaneously press the button [5] and the ON/OFF button [3] and hold them down.
4 Reinsert the batteries while holding down the buttons; pay attention to the correct polarity.
5
After inserting the batteries, continue holding down the button and the on/off button [3] for
another five seconds. " " is displayed and the measured values are deleted.
6.4 Transferring measured values to a computer
The GL40 measuring system has a built-in computer interface [4] which you can use to transfer the
measured values stored in your unit to a computer. (For the position of the connection socket, see
p. 10).
Beurer blood glucose software is available as a free download at www.beurer.com.
For more information, please read the instructions for use of the blood glucose diary software (also
available to download). These contain all the information you require for the data transfer.
The GL40 monitor is also compatible with Diabass and SiDiary.
Note
• An effective evaluation is possible only if you have correctly set the date and time (see p. 14).
• It is not possible to take a measurement during the data transmission.
• The measurement data remain stored on the measuring device after being transferred to the computer.