Beurer GL 44 (mg/dL) - Manual (Page 14)

14 Beurer GL44 mg/dL
4 i
nitial use and basic settinGs
4.1 Removing the battery insulation strips, replacing the batteries
Note
• Two batteries are included in the deliv-
ery scope of the blood glucose monitor.
These have already been inserted into
the battery compartment.
• Remove the insulation strip before initial
use.
1 Remove the battery compartment lid on the bottom side of the device.
2 Remove all batteries when replacing batteries. The device retains the date and time as long
as one battery is still inserted. If applicable, reset the date and time (see “Making and chang-
ing basic settings” on page 14).
3 Insert two new CR 2032 3 V batteries. Make sure that the batteries are inserted with the cor-
rect polarity, according to the label. Please observe the graphic in the battery compartment.
4 Subsequently close the battery compartment lid carefully.
Note
• The batteries are almost empty if the replace battery symbol appears. Replace both batteries
as soon as possible.
• If “ LP” appears on the display, the battery power level is so low that no more measurements are
possible.
4.2 Making and changing basic settings
1 Remove the batteries and reinsert them. Alternatively, press the “+” button
and the On/Off button for a minimum of five seconds.
An acoustic signal sounds.
The year display flashes.
rese
t
CR
20
32
CR
20
32