Beurer GL 44 (mg/dL) - Manual (Page 26)

26 Beurer GL44 mg/dL
6 m
easurement memory
For each measurement, your blood glucose value is automatically saved with the date and time un-
less “ ” was activated for a blood glucose measurement using control solution.
The memory can store a maximum of 480 measured values. If the memory is full, the oldest value is
replaced by the most recent value. You can call up every individual measured blood glucose value.
You can also calculate and display the average value for the last 7, 14, 30 and 90 days.
Note
• If you have already saved measured values and you reset the date, the average values are calculated
as from the new period.
• “---” indicates an empty memory for measured values. Press the On/Off button to switch off the de-
vice.
6.1 Displaying individual values
Individual values of the last 480 measurements are displayed. The most recent measured value is dis-
played first, and the oldest last. The blood glucose monitor simultaneously shows the date and time.
1 Switch the monitor on using the on/off button [4]. The initial display is shown briefly. Press
the “+” or “–” rocker switch [6].
2 “Mem” and the number of saved blood glucose tests are displayed briefly (Image 1). The
display then changes to the saved values including the measurement unit, date, time,
“Mem” and any possible highlighting. (Image 2).
Image 1 Image 2
3 Pressing the rocker switch “–” [6] will each time display the memory space number and then
the previous measured value. You can display a maximum of 480 previous measurements.
4 You can cancel the process at any time. For this purpose, press the On/Off button or wait
until the device switches itself off automatically after two minutes.