Comtech EF Data SLM-5650A - Manual (Page 175)

SLM-5650A Satellite Modem Revision 8
Network Processor (NP) Interface MN-SLM5650A
8–13
8.6.6.2.2 Admin | FAST Features
This section describes the NP HTTP/HTTPS Interface with Vipersat, Quality of Service (QoS),
and Management Security installed on the SLM-5650A.
If the SLM-5650A does not have these QoS or Vipersat FAST options installed, the
QoS and QoS Stats hyperlinks located under the WAN navigation tab, and the
hyperlinks located under the Vipersat navigation tab will not be visible/available to the
user.
If the SLM-5650A does not have the Management Security FAST option installed, the
“IP Interface Security Mode” and “SSH” sections on the Admin | Security page and the
“SNMP v3” section on the Admin | SNMP page will not be visible.
This read-only page displays available FAST Features as Installed or Not Installed.
Figure 8-7. Admin | FAST Features page
Network Processor and Modem FAST Features
Comtech EF Data offers Vipersat, Management Security, NP BPM, Quality of Service (QoS),
NP OW Serial Commands, and NP Antenna Handover functionality as optional FAST
Features for the NP Interface. The modem’s Demodulator Only FAST feature status is also
provided. To install these options, a modem FAST code must be purchased by contacting
Comtech EF Data Customer Support.
Once the 20-digit modem FAST code is obtained, the purchased FAST Feature(s) is installed via
the SLM-5650A front panel ( Utility: FAST  Configuration  Enter modem code).
See Chapter 5. FRONT PANEL OPERATION for detailed information on installing FAST
Features.
Upgrading the FAST features requires a modem reboot in order for FAST features to
be activated, and may require reconfiguration of all modem parameters.