Comtech EF Data SLM-5650A - Manual (Page 79)

SLM-5650A Satellite Modem Revision 8
Updating Firmware MN-SLM5650A
4–11
Step Task
7 Send a “ping” command to the TRANSEC Module to verify the connection and communication.
First, determine the IP address of the TRANSEC Module from the front panel:
SELECT: Configure  Transec  Module IP Address menus.
Then, using Command-line to “ping” the modem – at the prompt, type “ping xxx.xxx.xxx.xxx” (where
‘xxx.xxx.xxx.xxx’ is the TRANSEC Module’s IP address). The results should confirm whether or not the module is
connected and communicating.
8 Initiate a secure Web session with the SLM-5650A’s TRANSEC Module via its HTTPS Interface. The example
uses Internet Explorer Version 7.0.
From the PC, type https://xxx.xxx.xxx.xxx (where “xxx.xxx.xxx.xxx” represents the IP address of the TRANSEC
Module) into the Address area of the Web browser:
To log in to the secure interface, select Crypto Officer from the
navigation list that is provided in the upper left-hand corner of each
page, then click [Go!]. When prompted, enter the User Name and
Password at the Login page:
• Factory Default User Name is comtech;
• Factory Default Password is comtech.
9 Update the TRANSEC Module bulk firmware:
a) Open the Admin | Update Firmware page:
b) In the Bulk Firmware Upload section of the page, locate the update file downloaded to the PC during Steps
2 through 4 :
• Click [Browse]. The Choose File dialog box will open.
• Locate the folder created for the file download; double-click on the folder name to open the folder.
c) Select the update file, then click [Open]. The filename should appear in the Upgrade Bulk File text box.
d) Click [Upload] to begin the Firmware Application Process.