Comtech EF Data CDM-760 - Manual (Page 177)

Ethernet-based Remote Product Management Revision 2
CDM-760 Advanced High-Speed Trunking Modem MN-CDM760
7–19
• Use the Demo Mode drop-down list to select Demo-Mode as Off or On. Click [Update Demo
Mode] to execute the selection.
If an option is running that is not an activated (purchased) FAST Option at the time Demo
Mode is turned off, the modem will revert to all settings that were last valid before the
modem was put into Demo Mode. If all options running are activated (purchased) FAST
Options, the modem will not change its configuration.
7.4.4.3 Configuration Pages
Use these pages to configure all unit parameters. Click the Configuration navigation tab, and
then select the Modem, Interface, ARP, Routing, WAN, Utilities, Mask, Test, LNB, CID, or MEO
tab to continue.
7.4.4.3.1 Configuration | Modem
The Tx/Rx Interface Types and Framing Modes have higher priority than other
parameters. You must configure these settings before setting other parameters.
Figure 7-8. Configuration | Modem Page