Comtech EF Data CSAT-6070 - Manual (Page 99)

5 to 25 Watt C-Band Transceiver Revision 0
Redundant Systems MN/CSAT607025.IOM
Table B-6. M&C Signal Description (Connector J5)
Pin Signal Name Type Description
A RS485 RX+ Pass-thru RS-485 Rx+, From M&C to CSAT A&B
B RS485 RX- Pass-thru RS-485 Rx-, From M&C to CSAT A&B
C RS485 TX+ Pass-thru RS-485 Tx+, To M&C from CSAT A&B
D RS485 TX- Pass-thru RS-485 Tx-, To M&C from CSAT A&B
E B ONLINE CLOSED Output Shorted to pin K = CSAT B Online
F n.c.
G n.c.
H n.c.
J n.c.
K IND/FLT COMMON Input
L A FAULT OPEN Output Shorted to pin K = CSAT A Faulted
M B FAULT OPEN Output Shorted to pin K = CSAT B Faulted
N n.c.
P RED AUTO/MAN Input Ground = Manual, Open = Auto
R n.c.
S A ONLINE CLOSED Output Shorted to pin K = CSAT A Online
T GROUND Passive
U GROUND Passive
V SWITCH CMD Input Momentary short to GND, otherwise OPEN
B.2.1.6 T
X
IF I
NTERFACES
, J6, J7,
AND
J8
The Tx IF input signal is fed from the customers equipment to the RSU-5060 at connector J6.
The RSU-5060 contains a power splitter which feeds the IF input signal to both CSAT A and
CSAT B via the J7 and J8 connectors. The IF power at J7 and J8 will nominally be 3dB less than
the IF input power at J6.
B–5