Daktronics Fuelight FL-3000 and FL-4500 Series 36 and 48 Petroleum Price Display and Cash/Credit Display - Manual (Page 22)

16 Control Options Setup
9. Connect the receiver cable from receiver to the driver. Refer to Figure 31.
10. Neatly secure any excess cable with cable ties.
11. Close and secure the digit face.
Setting the Security DIP Switches
The FLR3-100 key fob has a series of dip switches on the back to give it a unique address setting. Set these
switches to a unique setting to prevent others from being able to control your display.
1. Remove the small cover on the back of the FLR3-100 key fob radio. Refer to Figure 32.
2. Using a paper clip or a micro screwdriver, set the switches to a unique setting.
Note: Do not change switches nine and zero.
3. Replace the back cover.
Mating the Key Fob with the Display
Follow these steps to mate the display with the FLR3-100/400 key fob. If these steps are not completed, the
display will not recognize or
respond to the key fob.
1. Turn power on to
the display.
2. While display is
booting up, or
within 5 minutes,
press and hold the
-1 and +1 buttons
until the decimal
flashes 3 times.
Refer to
Figure 32.
3. Once the decimal
point flashes 3
times, release the
buttons.
Figure 31: Final Receiver Assembly
Digit Cabinet
Driver
Receiver
Antenna Cable
LL-2855 REV00
CONFIG
ADDR
SYNC
4
3
2
LINE
1
TEST
1 2 3 4 5 6 7 8 9 0 ON
1 2 3 4 5 6 7 8 9 0 ON
Figure 32: FLR3 Key Fob DIP Switches