Daktronics Fuelight FL-3000 and FL-4500 Series 36 and 48 Petroleum Price Display and Cash/Credit Display - Manual (Page 33)

Using the FLR3-1500 and FLD3-2000 Handheld Console 27
Section 8: Using the FLR3-1500 and FLD3-2000
Handheld Controller
After power and signal installation, set up the handheld controller by using the following steps.
Connect the DM-100 Handheld Controller
8.1 Set Gas Price Function
To operate petroleum price displays, the handheld controller must first be programmed to the gas price
function. Use the
SET FUNCTION key on startup. The following tables list start-up procedures for both gas
price and rate (used for international displays).
Note: These steps only need to be performed the first time the controller is powered up.
LCD Screen Action
CURRENT FUNCTION
GAS PRICE
For indoor installation only: Plug the wall pack transformer into a 120 VAC
power outlet, and connect it to the DM-100.
This display appears briefly.
CHANGE FUNCTION?
PRESS SET FUNCT
This message appears next on the screen.
If GAS PRICE is shown on the bottom line of the LCD during startup, do
nothing. The controller automatically defaults to previous Gas Price settings.
If a function other than GAS PRICE is shown on the bottom line of the LCD
during startup, press the
SET FUNCTION key while the second LCD prompt
is displayed.
SELECT FUNCTION
GAS PRICE ↑↓
Press the Up and Down Arrow keys until the gas price option is shown.
Press the ENTER key to accept.