DFI G5C100-NR - Manual (Page 51)

51
2
Hardware Installation
Floppy Disk Drive Connector
The system board is equipped with a 26-pin FPC type floppy disk
drive connector. Only connect a 1.44MB slim-type floppy disk drive.
Floppy drives other than the one mentioned above are optional.
Refer to the next page for the pin function of this connector.
Connecting the Floppy Disk Drive Cable
Install one end of the floppy disk drive cable into the floppy disk
connector (FDC1) on the system board and the other end connec-
tor to the floppy drive. Pin 1 of the cable must align with pin 1 of
FDC1.
BIOS Setting
Enable or disable this function in the Integrated Peripherals submenu
(“Super I/O Device” section) of the BIOS. Refer to chapter 3 for
more information.
X
1