DFI G5C100-NR - Manual (Page 83)

8 3
3
BIOS Setup
IDE Primary Master/Slave UDMA and IDE Secondary Master/
Slave UDMA
These fields allow you to set the Ultra DMA in use. When Auto is
selected, the BIOS will select the best available option after checking
your hard drive or CD-ROM.
Auto The BIOS will automatically detect the settings for
you.
Disabled The BIOS will not detect these categories.
SATA Mode
IDE This option configures the Serial ATA drives in IDE
mode.
RAID This option enables the RAID function for Serial ATA
drives.
AHCI This option configures the Serial ATA drives in AHCI
mode.
On-Chip Serial ATA
Disabled Disables the onboard SATA.
Auto The system will detect the existing SATA and
IDE drives then automatically set them to the
available master/slave mode.
Combined Mode This option allows you to combine both IDE
and SATA drives; supporting maximum of 2
drives on each channel.
Enhanced Mode This option allows you to use both IDE and
SATA drives; allowing a maximum of 4 drives -
1 IDE Master, 1 IDE Slave and 2 SATA.
SATA Only This option automatically sets the SATA drives
to Primar y Master mode. Since the SATA
drives are in Master mode, you cannot set the
IDE drive to Master mode.
+