DFI G5C100-NR - Manual (Page 58)

58
2
Hardware Installation
Chassis Open Connector
The system board supports the chassis intrusion detection function.
Connect the chassis intrusion sensor cable from the chassis to J12.
Whenever a chassis component has been removed, the sensor
sends signal to J12 alerting you of a chassis intrusion event.
Hardware Monitor for Windows
Install the “Hardware Monitor for Windows” utility. By default, the
chassis intrusion detection function is disabled. When enabled, a
warning message will appear when the chassis is open. The utility can
also be configured so that a beeping alarm will sound when the
chassis is open. Refer to the “Hardware Monitor for Windows” sec-
tion in chapter 4 for more information.
1 2
Ground
Chassis signal
X