DR Power Chipper - Manual (Page 17)

CONTACT US AT www.DRpower.com 17
2. Remove the two Bolts, four Washers and two Locknuts that secure the
Deflector to the Chipper Assembly with two 1/2" wrenches and then remove
the Deflector (Figure 31).
3. Check to see if the Deflector opening is clogged. If it is, clear it with a
branch.
NOTE: You may need to remove the Belt from the Chipper Pulley so the Flywheel is
allowed to turn freely for the next step.
4. With a wooden stick, loosen and remove any material left in the Chipping
Chamber and make sure the Flywheel turns freely with the stick.
Reassemble:
1. Position the Deflector onto the Chipper Assembly and secure with two Bolts,
four Washers (one on each side) and two Locknuts using two 1/2" wrenches
(Figure 31).
2. Reconnect the spark plug wire, start the DR Field and Brush Mower engine,
engage the Blade Control Knob; allowing the remaining material in the
Chipping Chamber to discharge.
3. If the Chipping Chamber doesn’t clear and the flywheel is still jammed,
repeat above process.
NOTE: Be certain the Chipping Chamber is clear before trying to process more
material into the Chipper Hopper.
Figure 31
Discharge
Chute
Bolts and
Locknuts
Scroll
Weldment