DR Power Chipper - Manual (Page 8)

8 DR ®
CHIPPER ATTACHMENT
7. Cut open the Parts Box with a Utility Knife and remove the contents (Figure
5).
8. Remove the Bubble Wrap from the Discharge Chute.
9. Open the Product Package and remove contents.
10. Open the Hardware Package and remove contents.
Compare the contents of the Shipping Box, Parts Box and the Hardware
Package with the Parts Supplied list below. If there are any questions contact us
at www.DRpower.com or call 1-800-DR-OWNER (376-9637). Do not discard the
shipping materials until you are fully satisfied with your new DR CHIPPER
ATTACHMENT.
Parts Supplied:

Chipper Unit

Two Legs
 Two Leg Supports

Parts Box Containing: (items in list below and Figure 5)
o
Hopper
o
Discharge Chute
o
Belt
o Product Package Containing: Owners Manual, Wire Harness and
Hardware Package Containing: (items in table below and Figure 6)
Assembling the Chipper Attachment
Tools Needed:
 Two 1/2" Wrenches

Soft Faced Hammer
1. Position the Legs onto the Chipper Body and install the Bolts and Locknuts
snug but not tight (Figure 7).
2. Position the Leg Supports onto the Legs and install Bolts and Locknuts snug
but not tight.
3. Pull the Harness Connector down from where it is tucked into the front of
the Frame so it will hang from the Cable Tie.
4. Tip the machine up onto the Legs, straighten the Legs as needed, then fully
tighten the Leg and Leg Support Hardware.
H ARDWARE P ACKAGE C ONTENTS (F IGURE 7)
I TEM # D ESCRIPTION Q TY
1 Bolt, 5/16-18 X 4" 2
2 Carriage Bolt, 5/16-18 x 3/4" 4
3 Flat Washer, 5/16 8
4 Locknut, 5/16-18 24
5 Screw, 10-24 x 5/8" 1
6 Nut, Nylon Lock, 10-24 1
7 Bolt, 5/16-18 X 3/4" 18
8 Gap Gauge 1
9 Cable Tie 7
2
Figure 6
1
5
6
7
3
4
8
9
Figure 5
Hopper Discharge
Chute
Belt
Product Package (Owners Manual,
Hardware Bag, and Wire Harness)
Leg
Supports
Figure 7
Legs
Leg
Hardware
Leg Support
Hardware
Harness
Connector